Post Fader – This tap is affected by everything on the channel including fader movements, mute buttons, DCA levels, Gate, Dynamics EQ and insert.If the Insert is set to POST, this tap will pull before the insert is applied to the channel. You may also notice that if you have Dynamics set to PRE that the PostEQ signal tap and the PreFdr signal tap are the same things. I am getting no audio on S16 outputs 1-4 (feeding 2 more. Outputs 1-8 on the X32 (routed to 4 stereo IEM units) are working fine. The inputs are working fine however I am having some trouble with the outputs. Use the page select button to select these Output Tabs in order. Squeeze is a parameter which enhances the overall loudness and presence of the program material. Remember that the metering of the X32 and M32 is dBFS, which means that 0dB is clipping of the console and -18 dBFS would be unity gain. One thing to note, if you have Dynamics set to POST, this tap will pull audio off of the channel after the Dynamics. I have an X32 and an S16 to enable the use of more than 16 inputs, and to feed 6 stereo IEMs. The Output Gain is the overall volume level at the output of the limiter. Any channel fader movements will NOT affect the signal coming out of the output taps up to this point. PreFdr – This tap is before the channel fader.When the Dynamics is set to ‘POST’ then the ‘Post EQ signal tap’ is before the Dynamics section. The Dynamics is configurable to be pre or post EQ when it is set to ‘PRE’, the ‘Post EQ signal tap’ will include the dynamics as seen in the graphic below. (This would be beneficial if an inserted effect was desired, but not the EQ). There is also a configurable option to have the Insert before this tap, so you can have the Insert set to ‘PRE’ and have this tap pull the audio off of the channel after the insert. PreEQ – This tap is before the EQ but after the Gate.Being before any of the EQ and dynamics, this would be the cleanest unprocessed audio from each channel available. IN/LC – This tap is directly after the Input, Preamp Gain and Low Cut.In X32-Edit v3+ you will see them listed like this:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |